Camp Meeting : Satellite Broadcast : Manhattan Skyline 1000

Instructions For Programming
Manhattan Skyline 1000
To View Hope Church Channel

Adding New Transponder Information on Satellite AMC-4 (GE-4)

1. Using the remote control, press the MENU key, then press the right VOL key, the INSTALL box will highlight.
2. Press the down CH key once, and highlight 2. CHANNEL SEARCH. Now press the OK key, and the CHANNEL SEARCH window will open.
3. Press the down CH key 4 times until TP DATA is highlighted, then press the OK key. A TRANSPONDER DATA window will appear, on the right, with TP1:(xxxxxx) at the top in yellow.
4. Press the right VOL key until TP(x): USER DEFINED appears in yellow.
5. Press the down CH key once, and highlight FREQ. Enter the frequency 12116.900 for Hope Church Channel in the box.
   (This frequency may be slightly different for some receivers. See note on main instruction page.)
6. Press the down CH key twice, and highlight Symbol Rate (S/R). Type the Symbol rate 3.100 for Hope Church Channel.
7. Skip to step 8 if the Polarization is Horizontal. If it is not correct, press the Down CH key to highlight POLARIZATION and change.
8. It will take up to 15 seconds for the SIGNAL and QUALITY bars to turn green. Press the down CH key several times until STORE is highlighted in yellow. Press the OK key once and the TRANSPONDER DATA window will disappear.
9. Press the down CH key twice and highlight START. Press the OK key once and the receiver will automatically store the new channel(s), power off and repower.