Camp Meeting : Satellite Broadcast : Fortec Lifetime Ultra/Mercury II

Instructions For Programming
Fortec Lifetime Ultra/Mercury II
To View Hope Church Channel

Note: Before attempting to program new channels it may be necessary to make adjustments to the dish and/or LNB to obtain a strong signal that reflects good signal and quality levels. Poor signal quality will affect the ability to program and properly receive additional channels. A signal of 40% on a Fortec Star Mercury II will usually provide adequate signal to allow a search.

Select Power Search, press OK. Channels will be automatically programmed!

Or

Manually adding New Transponder / Channel Information.

1. Using the remote control, press the MENU key, if necessary press the right VOL key, to highlight INSTALLATION menu.
2. Press the down CH key twice, and highlight TP SCAN. Now press the OK key, and the TP SCAN window will open.
3. Press the right VOL key to select satellite AMC4Ku 101W
4. Press the down CH key once, and highlight FREQUENCY, then enter the frequency 12116.900 with the remote control numerical keys for Hope Church Channel.
   (This frequency may be slightly different for some receivers. See note on main instruction page.)
5. Press the down CH key once, and highlight Polarity. Press the right VOLUME key to select HORIZONTAL.
6. Press the down CH key once, and highlight SymbolRate. Type the symbol rate 3100 for Hope Church Channel.
7. Press the down CH key twice to highlight SAVE EDIT, press OK to store. Verify that the Signal Quality meter at the bottom of the screen indicates over 45% Quality reading.
8. Press the YELLOW (CALENDER) key to scan in Hope Church Channel.
9. At the completion of the scan a window appears “Do you want to save?”. Press the right VOL key to select YES then press OK key to save the new channel. The channel will automatically appear.